#Tippmann tipx paintball gun jam how to#

Most of them measure somewhere between 68 and a half to about 69 caliber range. If you take a closer look at paintballs made today, you’ll realize that 68 caliber brands range from. Leading paintball manufacturers are striving to make paintballs that are too small for bigger guns and too big for smaller guns. Although most manufacturers label their paintballs as 68 caliber, they try to find a size compromise as they look to manufacture balls that can shoot through a wide range of internal diameters that are used today. Understand the Different Paintball DiametersĪs you may already know, there are different sizes of paintballs. Today, there are paintball barrels with internal diameters that measure. Over time, the internal diameter of paintball guns has changed significantly. The reason for this indifference is that no trade organization has been officially endorsed or any globally recognized industry standards put in place. Know the internal diameter variations of the gun and barrelĪlthough nearly all modern paintball guns on the market are marked 68 caliber, most of them are not 68 caliber. 68 inches or sixty eight-hundredths of an inch. Caliber is measured in either hundredths or thousandths of an inch.

The term ‘ caliber’ is a measurement of the diameter of the paintball or barrel bore.

The majority of paintball guns are marked as 68 caliber, but most of them are not actually 68 caliber. If the issue isn’t fixed after this, keep reading for other possible causes. This process should fix a worn ball detent.

Place back all the screws in their respective places and tighten them.

Now make sure each part goes back to where it was initially.

Allow it to sink into the slot and sit behind the front bold.

Try a few more times if it proves to be challenging the first time. It’s in this slot that you are going to fit your new ball detent.

On the left side, just below the front bolt, you’ll see a slot that looks like it has been made for a ball detent.

You should now be able to see how the gun looks inside.

Now pull off the front part (the receiver part).

In most cases, the sear will pop out of its position.

Use the key to remove the screws, ensuring you don’t leave any screws unremoved.

Get the correct key for your screw size.

Here are the steps you need to follow to fix it: Replacing the ball detent depends on the model of the gun you are using.Īs mentioned above, one of the most likely reasons that paintballs are falling out of your barrel is a worn-out ball detent. If the ball detent is worn out, you have to replace it. If your barrel has a large diameter and you use paintballs with a small diameter, they may easily fall out. Paintballs often fall out of the barrel if they are either too small for your gun barrel, or you have a worn-out ball detent. Preventing Paintballs from Rolling Down the Barrel We’ll also discuss some other common problems that paintball gun owners deal with.

#Tippmann tipx paintball gun jam how to#

In this post, you are going to learn how to stop paintballs from falling out of the panel. Paintballs falling out of the barrel is a very common problem for paintballers.